TMB PERFORMANCE

Oil and filter replacement, refill to specification, service reminder reset where supported, and a basic visual leak check. Oil and filter extra.

Remove and inspect existing plugs, install correctly specified plugs, torque to specification, and reassemble. Plugs extra.

Replace ignition coil(s) and verify basic engine operation. Coils extra; misfire diagnosis is separate.

Drain and refill fluid as applicable, replace service filter/seals where applicable, set fluid level using the specified procedure, and check for visible leaks. Fluid, filter, seals, and parts extra.

Replace the engine air filter and verify proper fitment. Filter extra.

Drain and refill coolant, bleed or vacuum-fill as required, and check level and accessible connections. Coolant and parts extra.

Install intake kit, reconnect applicable sensors/hoses, and check fitment and clearances. Kit extra.

Remove required front-end components, install intercooler, reconnect charge pipes/hoses, and check connections. Parts extra; custom fabrication excluded.

Remove factory downpipe as required, transfer compatible sensors, install replacement, and check fitment and leaks. Parts/hardware extra; emissions compliance required.

Remove and install turbocharger, transfer compatible components, reconnect lines and hardware, and perform initial leak/operation checks. Turbo, gaskets, fluids, tuning, and additional upgrades extra.

Safely depressurize system, replace high-pressure fuel pump and applicable seals, then inspect for leaks and verify operation. Pump/seals extra.

Access in-tank pump assembly, install replacement pump or compatible upgrade, reassemble, and verify operation and check for leaks. Pump/seals extra; wiring, controller upgrades, and custom conversions extra.

Install the quoted downpipe and compatible exhaust sections, align components, and check clearances and leaks. Parts and hardware extra; fabrication excluded.

Read available fault codes and basic freeze-frame information, then explain initial findings. A scan is not a complete diagnosis.

Review symptoms and codes, analyze live data, perform targeted tests, and recommend next steps. Repairs and parts extra.

Review codes and symptoms, inspect relevant connections, review supported live data, and perform preliminary tests. Repairs and extended testing extra.

Smoke-test one defined intake, vacuum, or charge-air system and identify visible leaks. Repairs and additional systems extra.

Review supplied logs for relevant parameters such as boost, ignition correction, fueling, and fuel pressure where available. Custom calibration and testing extra.

Scope may include setup review, baseline logging or dyno testing, calibration adjustments, and verification. Licenses, dyno time, revisions, and hardware extra unless quoted.

1 hour; advanced electrical or tuning diagnostics billed by time.

Labor may be higher due to fitment issues and warranty considerations.

Charged separately unless included in a written estimate.

Rust, prior installation issues, custom fabrication, and aftermarket wiring may require additional labor.

Confirmed before work begins; additional work requires customer approval.